Skip to main content

Entry 8: SWOT Analysis (24 June 2018)

This entry will determine the SWOT Analysis for my project. The SWOT diagram below will determine the strengths, weakness, opportunities and threats of my chosen idea for my project.


Strength
Weakness

  •  Able to utilize new kind of controls into an arcade game environment
  • Able to understand new interface.




  • Specific hardware is required to make this project feasible. Hardware including custom made joysticks and Leap Motion.
  • Produce couldn’t be mass produced


Opportunity
Threats

  • Implementation of new kind of co-op experience in an arcade game environment
  • Brings new kind of interface into the market.


  • Mildly large physical space is required
  • Hard learning curve for interacting gestural controls

Comments

Post a Comment

Popular posts from this blog

Entry 21 : Building The Crank - 3D printing

This entry will be discussing about the continuity development for decorating the MO-3 crank. I've 3D modelled 3 items for printings: - 2 Handles (UpDown and LeftRight) - KEV-7 Leap Motion holder I took atleast 2 days prototyping the size of the 3D printed prototypes to see if it fits in the crank's handle. It took few prototype to find the correct scale. After settled with the correct scale, I've loaded up the Tronxy X1 3D printer with the handles. The first print was a success while not so for the other print. It was too big and technical error that causes the model to be displaced in layers. Thus, I loaded the same model and printed it again. It failed due to knotted 3D filaments. Third try was a success. Total it took 2 full nights to fully print 2 handles. After that I've loaded KEV-7 Leap Motion holder into a bigger 3D printer (beside FabLab's main Mac) and start printing the model. Due to too much pink 3D filaments, Ron and I decided to use the p...
Post a Comment
Read more