Skip to main content

Entry 13: Arcade Installation Design (6 July 2018)

This entry will focus onto the design of MO-3 and KEV-7's arcade installation.

The aspect of the design, according to me, must have:-
-platform for the controllers
-storage for PC and projector
-speaker box
-have two themes for MO-3 and KEV-7 respective themes
-exclude the screen

Design references :-


References based on the aspects stated above.

Initial Design: 

3/4 View of the MO-3 and KEV-7's arcade installation

Each component of the arcade installation will have their own functions

The 2 holes below the Controller Platform are intentional to be present to create a futuristic look and minimize resources. The Controller Platform is supported by the main body -the Storage (refer from "component")-


Size prox. 1/2 the size of an adult for comfort usage.

Comments

Post a Comment

Popular posts from this blog

Entry 21 : Building The Crank - 3D printing

This entry will be discussing about the continuity development for decorating the MO-3 crank. I've 3D modelled 3 items for printings: - 2 Handles (UpDown and LeftRight) - KEV-7 Leap Motion holder I took atleast 2 days prototyping the size of the 3D printed prototypes to see if it fits in the crank's handle. It took few prototype to find the correct scale. After settled with the correct scale, I've loaded up the Tronxy X1 3D printer with the handles. The first print was a success while not so for the other print. It was too big and technical error that causes the model to be displaced in layers. Thus, I loaded the same model and printed it again. It failed due to knotted 3D filaments. Third try was a success. Total it took 2 full nights to fully print 2 handles. After that I've loaded KEV-7 Leap Motion holder into a bigger 3D printer (beside FabLab's main Mac) and start printing the model. Due to too much pink 3D filaments, Ron and I decided to use the p...
Post a Comment
Read more